End of Season Demo Blow Out! prices are good while supplies last | Shop Now →

Hobie MD180 Turbo V1 - V2 Conversion Kit Part# 81501112
Mirage Drive Spine - molded for newer drives. (2013 and newer)This injection molded spine is the heart of the Mirage Drive. Like most of the other parts, it is extremely durable and failures are r
Hobie MD180 V2 Spine Assembly Part# 81527002
The Hobie Mirage Idler Pulley for the Mirage Drive GT is a replacement idler pulley for the Hobie Mirage Drive with Glide Technology. The idler pulley holds the idler cable which attaches to the Mirage Drive sprockets. The Mirage Drive
V1 MD180 ST Mast

Part Number: 81490001
Hobie’s bioengineered MirageDrive propulsion system for pedal kayaks was revolutionary in its inception in 1996 and has been evolving ever since. The MirageDrive 180 forward-reverse propulsion system is integrated into most MirageDrive kayaks. See individ
Mirage Drive ST Turbo Mast - Threaded for V2 drives.A replacement mast for the ST Turbo fins only. It is too long for the other fins.These
Hobie MD180 V2 Turbo Fin Part# 81501002
Right pedal crank assembly for V1 and V2 Mirage Drive
We believe that kayaking and fishing should be accessible, rewarding and—above
all else—fun. This starts with locomotion. For many kayakers, long hours of paddling
can dampen their fun factor, and paddle splashes can startle fish and wildlife. So
we as
Hobie MD180 V2 ST Fin Part# 81500002
Hobie MD180 V2 Only ST/Turbo Fin Conversion Kit Part# 72067002
Hobie MD180 Shifter Set Right (Reverse) V2 Part# 81491021
Hobie - Sprocket GT Threaded With Bearings 
These pedals are for the inflatable hobie kayaks.

At Hobie, helping people have unforgettable on-the-water experiences, ranks supreme
Mirage Drive Idler Cable - For new drives with the molded drum. 18.5"inches long

The Hobie Mirage Idler Cable V2 is the replacement i
Hobie Mirage ST Fins Part# 81193021
Hobie Roller Bearing Sprocket Part# 81156301
Mirage Drive Sprocket Guard- for newer Mirage Drives with nylon sprockets. Priced each. Two Required per drive.The Sprocket Guard slides over the front end of the sprocket. It helps to streamline the lower end of the drive and keep debris out of the chain
Mirage Drive Sprocket Shaft - for both newer and older drives.The sprocket shaft is held into the spine by a set screw located between the sprockets. Since it is stainless steel, it should be a low failure item. But it is possible to bend the shaft if the
Mirage Drive Drum Shaft - for both old and new drives.This stainless steel shaft carries the majority of the peddling load. It's held into the drive spine by friction only. It's a very low wear item and should not need replacing unless the drive fails and